Rhinocam2 and Mach3 Problem
Posted by
Jack Mc Kie
on 2009-03-03 12:22:51 UTC
I have been happily using Rhinocam V1 and liking it. Ver 2 came out
and I just tried to use it and ended up with problems.
I was making a simple 2.5D part each time I tried to run the program
posted from Rhinocam2 Mach3 either gives me an abnormal warning light
with the cause being displayed as " Exact Stop vs CV Mode" or locks
up. I managed to get the one off part made but didn't like running
with a warning light on.
The warning light comes on when it reaches this line in the program
G81 X0.5000 Y0.2810 Z-0.6 R0.1
I'm pretty rank with both Rhinocam2 and Mach3. Until this they have
been pretty cookbook but....
Anyone have any ideas about this problem???
Jack
and I just tried to use it and ended up with problems.
I was making a simple 2.5D part each time I tried to run the program
posted from Rhinocam2 Mach3 either gives me an abnormal warning light
with the cause being displayed as " Exact Stop vs CV Mode" or locks
up. I managed to get the one off part made but didn't like running
with a warning light on.
The warning light comes on when it reaches this line in the program
G81 X0.5000 Y0.2810 Z-0.6 R0.1
I'm pretty rank with both Rhinocam2 and Mach3. Until this they have
been pretty cookbook but....
Anyone have any ideas about this problem???
Jack
Discussion Thread
Jack Mc Kie
2009-03-03 12:22:51 UTC
Rhinocam2 and Mach3 Problem
reyals33
2009-03-04 10:18:08 UTC
Re: Rhinocam2 and Mach3 Problem