Re: [CAD_CAM_EDM_DRO] help with cad closing points or lines
Posted by
William Thomas
on 2009-04-01 02:34:23 UTC
Hi Gary and All:
Double check the radius for the ends down to four places. What often happens is
that you have the radius as .281" and the slot width as .5625". The arc will not meet the side
of the slot as it as it is off by .0005". This a common problem with arc's.
GOD'S BLESSINGS
Bill
On Tue, 31 Mar 2009 19:12:01 -0000, gorf242003 wrote
Open WebMail Project (http://openwebmail.org)
[Non-text portions of this message have been removed]
Double check the radius for the ends down to four places. What often happens is
that you have the radius as .281" and the slot width as .5625". The arc will not meet the side
of the slot as it as it is off by .0005". This a common problem with arc's.
GOD'S BLESSINGS
Bill
On Tue, 31 Mar 2009 19:12:01 -0000, gorf242003 wrote
> I have 2 slots 9/16 wide they have a slight radius,--
> When i put in a cam program to setit up for the cuts, and i try to have it do an inside profile, one side of the arc will show an inside path the other side will only give me an outside path.
>
> I tried turbocad12 and autocad2009 i assume i am getting this problem from not have a closed line, i can't seem to get it to close, is there a trick i am missing, i tried close polyline but i get the same results.
>
> Thanks gary
>
>
Open WebMail Project (http://openwebmail.org)
[Non-text portions of this message have been removed]
Discussion Thread
gorf242003
2009-03-31 12:13:12 UTC
help with cad closing points or lines
William Thomas
2009-04-01 02:34:23 UTC
Re: [CAD_CAM_EDM_DRO] help with cad closing points or lines
rwwink
2009-04-01 05:25:44 UTC
RE: [CAD_CAM_EDM_DRO] help with cad closing points or lines