CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Hi Group Long time not here

Posted by Dan Mauch
on 2010-05-11 08:18:00 UTC
It's important to get a good driver. I would recommend the Gecko G203 for that large a motor.

Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch
----- Original Message -----
From: marble_h
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Tuesday, May 11, 2010 6:59 AM
Subject: [CAD_CAM_EDM_DRO] Hi Group Long time not here



Hi group it has been a lot of years since I have been in the group .Well I am back and looking at finely changing my Smithy over to CNC I went on to e-bay and found a seller,selling Nema 34 stepper motor 872 oz.in and driver for 270.00 plus shipping.since I have been out of this for such a long time I think the cost is not to bad but what do you fine people think .

John





[Non-text portions of this message have been removed]

Discussion Thread

marble_h 2010-05-11 07:01:54 UTC Hi Group Long time not here Dan Mauch 2010-05-11 08:18:00 UTC Re: [CAD_CAM_EDM_DRO] Hi Group Long time not here John 2010-05-11 11:27:40 UTC Re: Hi Group Long time not here