Re: [CAD_CAM_EDM_DRO] recycling computers
Posted by
William Thomas
on 2010-12-01 13:44:30 UTC
Hi Jon:
I will check out an old unit I had about fifteen years ago when I purchased my Backtrack CNC mill. I run into problems with the software and never got it going because of health issues.(hit by a car while walking) Did these not have a small round battery on the mother board. That went dead on mine. I talked with you at the CNC WORKSHOP about my NOS 1978 lathe with servo motors.
GOD'S BLESSINGS
Bill Thomas
On Mon, 29 Nov 2010 13:39:08 -0600, Jon Elson wrote
Open WebMail Project (http://openwebmail.org)
[Non-text portions of this message have been removed]
I will check out an old unit I had about fifteen years ago when I purchased my Backtrack CNC mill. I run into problems with the software and never got it going because of health issues.(hit by a car while walking) Did these not have a small round battery on the mother board. That went dead on mine. I talked with you at the CNC WORKSHOP about my NOS 1978 lathe with servo motors.
GOD'S BLESSINGS
Bill Thomas
On Mon, 29 Nov 2010 13:39:08 -0600, Jon Elson wrote
>--
>
> ebiz_59 wrote:
> > I started to clean up a pile of computers that I've been acquiring for last dozen years.
> Hey, if you have a 286, I'd be real interested in the motherboard only.
> I have a pick and place machine
> that has a 286 in it (has a little cast aluminum heat sink on the CPU)
> and I had already dumped all that
> ancient junk when I got this machine. It still works fine, but you
> never know when something might go
> out on it. it is not upgradeable, it is a 286, but not a PC. It has a
> board about 18" square with big
> rows of EPROMS and battery-backed SRAMS. The architecture is not that
> far from a PC, but there's
> no OS, no ISA slots, etc.
>
> Jon
>
>
Open WebMail Project (http://openwebmail.org)
[Non-text portions of this message have been removed]
Discussion Thread
ebiz_59
2010-11-29 06:26:27 UTC
recycling computers
Jon Elson
2010-11-29 11:39:20 UTC
Re: [CAD_CAM_EDM_DRO] recycling computers
Chuck Merja
2010-11-29 18:48:17 UTC
RE: [CAD_CAM_EDM_DRO] recycling computers
William Thomas
2010-12-01 13:44:30 UTC
Re: [CAD_CAM_EDM_DRO] recycling computers
Jon Elson
2010-12-01 19:57:55 UTC
Re: [CAD_CAM_EDM_DRO] recycling computers