Re: [CAD_CAM_EDM_DRO] cable for printer port

On 2/3/2011 8:04 PM, John wrote:

>
> Hi group I am now just hooking up EMC and I am making up the 2 pin
> printer hook up what type of wiring is used I have a few types here
> from older projects
> One is a 16 wire cable shielded all it said on the out side is
> helukable super Paar tronic C Pur c tried the web site and I could not
> find any info on it I was going to use this and a extra 6 wire to make
> it up I think it shold be ok but I am asking to make sure
>
> John
>

Cables are dirt cheap on ebay.

--


Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA

There are two kinds of posts on newsgroups.
1. This is what I have done...
2. This is what I think...
Be aware of the difference!

http://www.ourcadguy.com/

http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/

Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/








[Non-text portions of this message have been removed]