Re: [CAD_CAM_EDM_DRO] X axis yaw on CNCd G8689
Posted by
Ron Thompson
on 2011-04-13 06:34:46 UTC
On 4/12/2011 11:56 PM, Chuck Merja wrote:
--
Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
There are two kinds of posts on newsgroups.
1. This is what I have done...
2. This is what I think...
Be aware of the difference!
http://www.ourcadguy.com/
http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/
Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/
[Non-text portions of this message have been removed]
>That is what I would do.
> Sorry for the repost - didn't get any bites last week.
> I thought I'd start a new topic for this (as opposed to continuing the
> tool
> size > hole dia). I have a G8689 converted to CNC and it still has ACME
> screws. In cutting the holes using the CNC, I get holes that aren't too
> round. PArt of the problem is that I need to better characterize the
> backlash in MACH, but I also noticed that I have some significant yaw
> issues
> with the X axis - except at the end points of travel, where the ways
> tighten
> up so much that the steppers miss steps. So, it looks like I need to
> rework
> the ways on this mini mill - any suggestions???? I have a pretty good
> Bridgeport that I could toss this little table on and try to
> straighten the
> ways, or is this a dumb idea? thanks, C
>
--
Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
There are two kinds of posts on newsgroups.
1. This is what I have done...
2. This is what I think...
Be aware of the difference!
http://www.ourcadguy.com/
http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/
Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/
[Non-text portions of this message have been removed]
Discussion Thread
ebiz_59
2011-04-05 10:13:41 UTC
X axis yaw on G8689
Chuck Merja
2011-04-12 20:56:40 UTC
[CAD_CAM_EDM_DRO] X axis yaw on CNCd G8689
Ron Thompson
2011-04-13 06:34:46 UTC
Re: [CAD_CAM_EDM_DRO] X axis yaw on CNCd G8689
Mike
2011-04-13 12:57:58 UTC
Re: X axis yaw on CNCd G8689
Chuck Merja
2011-04-14 08:14:11 UTC
RE: [CAD_CAM_EDM_DRO] Re: X axis yaw on CNCd G8689
Chuck Merja
2011-05-01 16:47:54 UTC
RE: [CAD_CAM_EDM_DRO] Re: X axis yaw on CNCd G8689