[CAD_CAM_EDM_DRO] Re: Shaft balancing
Posted by
Roland Jollivet
on 2011-11-01 11:41:05 UTC
Thing is, I want to be able to balance in selected planes, with add or
subtract. I'm after something like this, but not wanting to spend $000's;
http://www.dynamic-balancing.com/software.htm
I want to be able to balance small spindles to 30 000 or so, to mg
resolution, using accelerometers and some PC interface I/O. I can do all
the hardware, but the software is troublesome..
Regards
Roland
subtract. I'm after something like this, but not wanting to spend $000's;
http://www.dynamic-balancing.com/software.htm
I want to be able to balance small spindles to 30 000 or so, to mg
resolution, using accelerometers and some PC interface I/O. I can do all
the hardware, but the software is troublesome..
Regards
Roland
On 1 November 2011 14:13, turbulatordude <dave_mucha@...> wrote:
> **
>
>
> old style car wheel balancers would fit in place of the hub cap, and have
> 4 adjustment screws.
>
> there would be 2 weights and once set of screws would move the weights to
> one side or the other. the second set of adjusting screws would move a
> weight that was set perpendicularly.
>
> one would feel the vibration and keep adjusting until the wheel ran
> smooth. the indicator would show where to place the lead weight and how
> many ounces to use.
>
> not software, but practical.
>
> Dave
>
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, Roland Jollivet <Roland.Jollivet@...>
> wrote:
> >
> > Hi
> >
> > Is anyone aware of free software used for dynamically balancing shafts?
> Or
> > maybe someone has written something?
> >
> > Regards
> > Roland
> >
> >
> > [Non-text portions of this message have been removed]
> >
>
>
>
[Non-text portions of this message have been removed]
Discussion Thread
Roland Jollivet
2011-10-15 10:03:00 UTC
[CAD_CAM_EDM_DRO] Shaft balancing
William Thomas
2011-10-31 09:49:40 UTC
Re: [CAD_CAM_EDM_DRO] Shaft balancing
turbulatordude
2011-11-01 05:16:19 UTC
Re: Shaft balancing
Roland Jollivet
2011-11-01 11:41:05 UTC
[CAD_CAM_EDM_DRO] Re: Shaft balancing
Steve Blackmore
2011-11-01 17:14:30 UTC
Re: [CAD_CAM_EDM_DRO] Re: Shaft balancing
Roland Jollivet
2011-11-01 17:49:24 UTC
[CAD_CAM_EDM_DRO] Re: Shaft balancing
inv_inv2006
2011-11-02 05:39:18 UTC
Re: Shaft balancing
William Thomas
2011-11-02 09:54:41 UTC
Re: [CAD_CAM_EDM_DRO] Re: Shaft balancing