Re: [CAD_CAM_EDM_DRO] Stepper motor connection
Posted by
Ron Thompson
on 2013-01-30 21:31:13 UTC
On 1/30/2013 3:26 PM, erokc0 wrote:
each motor.
However, as proven by Reprap 3D printers, it is possible to drive two
motors from a single driver, provided the driver provides adequate
amperage.
The motors are wired in parallel to each other.
http://reprap.org/wiki/RAMPS_1.4#Wiring
--
Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
Think, Draw, Print. 3D printers ROCK!
http://www.plansandprojects.com/My%20Machines/PrusaMendel2012-1/
http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/
Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/
> I have a need to position two arms that will always be at the sameConventional wisdom hold that you need two separate drivers, one for
> angle but are not easy to connect to one drive. I want to use two
> stepper motors, one for each arm. The motor will run a nut on a screw
> no more than three inches total.
>
> Can I connect the motor windings in series given the power supply and
> driver has sufficient voltage and current? Would there be any reason
> they would not step together?
>
> The motors are six wire, unipolar. My driver is bipolar.
each motor.
However, as proven by Reprap 3D printers, it is possible to drive two
motors from a single driver, provided the driver provides adequate
amperage.
The motors are wired in parallel to each other.
http://reprap.org/wiki/RAMPS_1.4#Wiring
--
Ron Thompson
On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
Think, Draw, Print. 3D printers ROCK!
http://www.plansandprojects.com/My%20Machines/PrusaMendel2012-1/
http://www.plansandprojects.com My hobby pages are here:
http://www.plansandprojects.com/My%20Machines/
Visit the castinghobby FAQ:
http://castinghobbyfaq.bareboogerhost.com/
Discussion Thread
erokc0
2013-01-30 18:55:05 UTC
Stepper motor connection
Ron Thompson
2013-01-30 21:31:13 UTC
Re: [CAD_CAM_EDM_DRO] Stepper motor connection
cnc sales
2013-01-31 13:01:17 UTC
Re: [CAD_CAM_EDM_DRO] Stepper motor connection
erokc0
2013-01-31 16:04:18 UTC
Re: Stepper motor connection
Earle Rich
2013-01-31 18:44:04 UTC
Re: Stepper motor connection
cnc sales
2013-02-01 02:01:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper motor connection
Ron Thompson
2013-02-01 08:21:55 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper motor connection
cnc sales
2013-02-01 09:19:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper motor connection
Henrik Olsson
2013-02-01 12:59:57 UTC
[CAD_CAM_EDM_DRO] Re: Stepper motor connection