CAD CAM EDM DRO - Yahoo Group Archive

Win 10 Preview on a Laptop with the ESS

Posted by
on 2015-06-25 11:15:44 UTC

 2 out of 5 voices in my head :) told me to go for it. So load reluctantly loaded win 10 Preview on my laptop so I could access a flash program only in win 10 to flash the iso file of win 10 IOT build for a Raspberry Pi 2 onto a SD card. Installing  win 10 on my quad core AMD A6 laptop went well. After flashing the SD card I decided to try and see if win 10 would work with the Ethernet Smooth Stepper ( ESS) and my G540 5 axis control unit.  The laptop previously had win 8.1 and had run the ESS in the past. However, when I ran Mach3 I was surprised that the ESS plugin wasn't there. So I copied it from a pen drive and ran it. It installed fine. I also had to go into the control panel and setup the IP address of the ESS and the Mask. After that I had to enable the plugin by resetting the devices on loading mach3 and enabled it in the config plug. After restarting Mach3 the wonderful FPGA screen loaded and Mach3 came up but the screen was blank. I then clicked on View>Load Screens and selected a screen and loaded it. I bench ran all 5 motors and they seem to be normal in all respects. Now if I can get the Rasberry pi 2 to run mach3 that would be great.


Dan Mauch

22 Anniversary in CNC

Camtronics Inc

Camtronics, inc. -- CNC with Dan Mauch

dmauch@...

Proud builder of gecko products



Discussion Thread

2015-06-25 11:15:44 UTC Win 10 Preview on a Laptop with the ESS 2015-06-26 08:59:26 UTC Re: Win 10 Preview on a Laptop with the ESS