Re: [CAD_CAM_EDM_DRO] G02 - G03

Actually, on reading that last letter, I guess I better look at R again.
It's somewhat hard to get your head around from a software standpoint.

----- Original Message -----
From: "Tim Goldstein" <timg@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, August 21, 2000 11:11 AM
Subject: RE: [CAD_CAM_EDM_DRO] G02 - G03


> I would vote for using R as I can understand that one and almost follow
the
> code when reading it over. The IJK seems pretty tough to follow unless you
> want to sit down and work at it real hard.
>
> Tim
> [Denver, CO]
>
> > -----Original Message-----
> > From: Art Fenerty [mailto:fenerty@...]
> > Sent: Monday, August 21, 2000 3:22 PM
> > To: CAD_CAM_EDM_DRO@egroups.com
> > Subject: [CAD_CAM_EDM_DRO] G02 - G03
> >
> >
> > Hi:
> >
> > I am trying to update MasterControlCNC to do G02
> > and G03 circular interpolation and although I now have
> > working code ( thanks
> > to Doug Fortune) I don't quite understand which is the most
> > common form of
> > interp.
> > My post processor on the software I use the most does
> > not generate circ. only linear. Am I better off using R
> > registers or IJK
> > interp? or both? Is IJK now pretty much obsolete?
> >
> > Art
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>