Re: [CAD_CAM_EDM_DRO] G02 - G03
Posted by
Darrell
on 2000-08-21 16:16:19 UTC
IJK is the most accurate. R is probably easier to under stand. Along with
IJKs accuracy is the requirement for your numbers to be accurate. Most
controls have a tolerance parameter that determines when the control errors
out.
Darrell
IJKs accuracy is the requirement for your numbers to be accurate. Most
controls have a tolerance parameter that determines when the control errors
out.
Darrell
----- Original Message -----
From: "Art Fenerty" <fenerty@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, August 21, 2000 2:22 PM
Subject: [CAD_CAM_EDM_DRO] G02 - G03
> Hi:
>
> I am trying to update MasterControlCNC to do G02
> and G03 circular interpolation and although I now have working code
thanks
> to Doug Fortune) I don't quite understand which is the most common form of
> interp.
> My post processor on the software I use the most does
> not generate circ. only linear. Am I better off using R registers or IJK
> interp? or both? Is IJK now pretty much obsolete?
>
> Art
>
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>
Discussion Thread
Tim Goldstein
2000-08-21 11:07:18 UTC
RE: [CAD_CAM_EDM_DRO] G02 - G03
Art Fenerty
2000-08-21 11:13:11 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03
Art Fenerty
2000-08-21 11:15:40 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03
Jon Anderson
2000-08-21 11:35:05 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03
Jon Elson
2000-08-21 12:03:50 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03
Darrell
2000-08-21 16:16:19 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03
Darrell
2000-08-21 16:17:58 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03
Art Fenerty
2000-08-21 17:17:07 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03
diazden
2000-08-22 17:41:45 UTC
Re: [CAD_CAM_EDM_DRO] G02 - G03