Re: [CAD_CAM_EDM_DRO] Through hole plating

On small boards, many through hole parts can be soldered on both sides.
Other holes just put a piece of wire wrap wire through and solder.
Darrell

----- Original Message -----
From: "James Owens" <wotisname@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Friday, September 01, 2000 10:58 PM
Subject: [CAD_CAM_EDM_DRO] Through hole plating


>
> Hi All,
>
> I know this question is not within the remit of the list but I will be
using
> the information to produce my own driver boards.
>
> Does anyone know how I can through hole plate the drilled holes on a
circuit
> board using technology that is available to the home-shop. I have also
hear
> of a cold plating process for the tracks, I am also looking for
information
> on that as well.
>
> Thank you in advance,
>
> Regards,
>
> Terry
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>