Re: [CAD_CAM_EDM_DRO] RH Linux 5.2 will not boot
Posted by
Ray Menke
on 2000-09-03 13:26:40 UTC
On Sun, Sep 03, 2000 at 01:47:53AM -0000, don.pat.brock@... wrote:
one of the partitions active. If you do "fdisk -l", it will show a
listing of your partitions. One of them should have an asterisk under
the column headed boot. (I just checked this on my RH5.2 system.) Hope
this helps.
--
Ray Menke RnDMenke@...
Linux/Mutt 0.95.3i/emacs/sendmail/fetchmail from the tty console.
> fine but will not boot from the HD or a floppy. I keep getting aYou need to make the boot partition active. Run fdisk again and make
> bios message that no ***active*** partition was found on the HDD. I
> work around to this problem? Linux fdisk shows 4 partitions all
one of the partitions active. If you do "fdisk -l", it will show a
listing of your partitions. One of them should have an asterisk under
the column headed boot. (I just checked this on my RH5.2 system.) Hope
this helps.
--
Ray Menke RnDMenke@...
Linux/Mutt 0.95.3i/emacs/sendmail/fetchmail from the tty console.
Discussion Thread
don.pat.brock@p...
2000-09-02 18:47:59 UTC
RH Linux 5.2 will not boot
Tim Goldstein
2000-09-02 19:57:30 UTC
RE: [CAD_CAM_EDM_DRO] RH Linux 5.2 will not boot
don.pat.brock@p...
2000-09-02 22:41:06 UTC
Re: RH Linux 5.2 will not boot
Ray Menke
2000-09-03 13:26:40 UTC
Re: [CAD_CAM_EDM_DRO] RH Linux 5.2 will not boot
don.pat.brock@p...
2000-09-03 20:12:19 UTC
Question for Ray Menke
Ray Menke
2000-09-05 09:27:59 UTC
Re: [CAD_CAM_EDM_DRO] Question for Ray Menke