Re: CNC flame/plasma cutter
Posted by
MIADsgns@x...
on 1999-06-25 13:02:33 UTC
In a message dated 6/25/99 5:40:37 AM SA Eastern Standard Time,
PTENGIN@... writes:
<<
I have use of a Miller 187D Plazma Cutter. This unit is a small 110V unit.
It
can cut up to 3/16" thick steel. In copper or Aluminum, heat loss is so high
that only approx 1/16" thick material can be cut. In stainless steel and
steel, if you are patient, you can cut 1/4". In steel, approx 16 Ga, you get
a kerf of approx. .025". Hope this helps. Peter >>
What is the cost of such cutter and where can I buy it from?
Mario
http://members.aol.com/microchper/mia280.htm
PTENGIN@... writes:
<<
I have use of a Miller 187D Plazma Cutter. This unit is a small 110V unit.
It
can cut up to 3/16" thick steel. In copper or Aluminum, heat loss is so high
that only approx 1/16" thick material can be cut. In stainless steel and
steel, if you are patient, you can cut 1/4". In steel, approx 16 Ga, you get
a kerf of approx. .025". Hope this helps. Peter >>
What is the cost of such cutter and where can I buy it from?
Mario
http://members.aol.com/microchper/mia280.htm
Discussion Thread
Tim Goldstein
1999-06-23 21:29:03 UTC
Re: CNC flame/plasma cutter
Dan Mauch
1999-06-24 06:30:28 UTC
Re: CNC flame/plasma cutter
Andy Olney
1999-06-24 07:17:20 UTC
Re: CNC flame/plasma cutter
John Grant
1999-06-24 08:38:53 UTC
Re: CNC flame/plasma cutter
Robert Campbell
1999-06-24 09:18:07 UTC
Re: CNC flame/plasma cutter
Ted
1999-06-24 15:49:15 UTC
Re: CNC flame/plasma cutter
MIADsgns@x...
1999-06-24 15:47:07 UTC
Re: CNC flame/plasma cutter
PTENGIN@x...
1999-06-25 01:39:51 UTC
Re: CNC flame/plasma cutter
MIADsgns@x...
1999-06-25 13:02:33 UTC
Re: CNC flame/plasma cutter
PTENGIN@x...
1999-06-25 23:01:32 UTC
Re: CNC flame/plasma cutter