CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Transformer

Posted by Bill Darby
on 2000-09-15 05:27:45 UTC
Hi all

On the subject of transformers: Is there any way to determine what a used transformer is able to do for you. Could you
calculate current load, primary windings, secondary windings and various shunts etc.? Or are they just garbage if you don't "know"
which leads are which.

Bill D

Jon Elson wrote:

>
> Ozzie@... wrote:
>
> > Can I use a stepup (115v to 220v)transformer in reverse and apply
> > 115v to the output and get approx 55v output??
>
> Yes, this should work fine. If there is no current rating, just a KVA
> rating,
> you have to compute the current at the original voltage for the current
> to come out right.
>
> Jon
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

Discussion Thread

JanRwl@A... 2000-09-14 18:46:27 UTC Re: [CAD_CAM_EDM_DRO] Transformer Ozzie@h... 2000-09-14 19:33:38 UTC Re: Transformer Jon Elson 2000-09-14 22:58:55 UTC Re: [CAD_CAM_EDM_DRO] Transformer Bill Darby 2000-09-15 05:27:45 UTC Re: [CAD_CAM_EDM_DRO] Transformer Kevin P. Martin 2000-09-15 07:53:42 UTC RE: [CAD_CAM_EDM_DRO] Transformer Jon Elson 2000-09-15 11:06:46 UTC Re: [CAD_CAM_EDM_DRO] Transformer Ian Wright 2000-09-15 13:58:15 UTC Re: [CAD_CAM_EDM_DRO] Transformer JanRwl@A... 2000-09-15 18:40:19 UTC Re: [CAD_CAM_EDM_DRO] Transformer JanRwl@A... 2000-09-15 19:53:56 UTC Re: [CAD_CAM_EDM_DRO] Transformer Jon Elson 2000-09-15 23:22:19 UTC Re: [CAD_CAM_EDM_DRO] Transformer