Re: [CAD_CAM_EDM_DRO] Where to buy a servo (inexpensively)...

Doug;
$760 each for Baldor 650 in.lb. servos is about half of list price. That's
a good discount.
I paid $770 each for 450 in.lb. Baldors which list for $1145.

Where are you located?

Doug Harrison

----- Original Message -----
From: <dougrasmussen@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Saturday, September 16, 2000 10:35 PM
Subject: [CAD_CAM_EDM_DRO] Where to buy a servo (inexpensively)...


>
> Group,
>
> I need a servo motor. Specs are off the old Baldor motor.
> 650 oz in. 2500 max rpm. 150 VDC max. Tachometer and 1000 line
> encoder.
>
> My Y-axis motor went south (most likely got coolant in it). The
> machine's control maker has new motors for $760, ready to bolt in.
> Except they're out of stock until 9-25. The price isn't too
> outrageous since it gets you back up making money right away.
>
> If I can find an equivalent for a good price I might go that route.
> Even if I'd have to spend a little effort soldering the connections
> for the cable.
>
> In the past whenever I've had a bad servo I've had one overnighted
> from the dealer and was running again within 24 hours. This time I
> don't have that option. My other option is to buy a rebuilt motor
> with correct cabling from a CNC repair outfit, but they want quite a
> bit more for the rebuilt than a new one costs!!!
>
> thanks,
>
> Doug
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>