Re: deskNC

I have no experience with DesKAM, but I have used DeskNC DOS version and
found it a little difficult to set up but very easy to use one configured. I
would highly recommend it for someone just starting with CNC and looking for
a program that can drive steppers from g-code. It does seem to drive the
steppers less smoothly than EMC, but I did not find this to be detrimental
to the program.

Tim
[Denver, CO]

----- Original Message -----
From: <TADGUNINC@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Monday, June 28, 1999 10:24 PM
Subject: Re: [CAD_CAM_EDM_DRO] deskNC


> From: TADGUNINC@...
>
> Has anyone used deskNC, or desKAM? Would either of these be a decent start
to
> get comfortable with cnc machining?
> Tracey
>
> --------------------------- ONElist Sponsor ----------------------------
>
> Attention ONElist list owners.
> http://www.onelist.com
> We've just added a "NO ATTACHMENTS" option. See homepage for details.
>
> ------------------------------------------------------------------------
> Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> bill,
> List Manager
>