Re: [CAD_CAM_EDM_DRO] Xmas in October

John,
I use a lapidary gem saw (diamond) to cut glass tubing (pyrex high pressure boiler water
gage). I'm sure a scale is no problem. There may be other considerations tho.
A gem/rock shop may do it for you on their cab saw.
Rich D.

John Brauweiler wrote:

>
> Hi there Group I think today is Christmas day for me at work to the
> R&D department was going to thow out an DRO for a lathe it has Both
> X & Y scales The best part still working , a little dirty, but
> working > Now the question can one cut the glass inside to make it
> smaller to fit my Smithy .. Cross feed is ok but the long scale is
> 48" long any help would be help full . I also received an power
> supply tonight 110 in and 12Volt 33 amps out. This thing is big just
> now to think of a way to use it ..I will post pics of both this week
> end
> John
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

--
-==Rich=-=Colorado Midland Railway=-=cmsteam@...=-Atlanta-
----------Moseley Dynamo Repair, Rebuild, Update Service----------