Re: [CAD_CAM_EDM_DRO] maxnc/sherline
Posted by
Ron Ginger
on 2000-10-12 10:49:08 UTC
tauseef wrote:
and they are OK. I also have the Camtronics board. I do have the
Sherline Z axis fitted with a pulley drive of about 1:1.5 ratio. I thnk
this helps on lifitng the motor. I dont mind if Z goes slower, its
little use in most work I do on the Sherline.
Ive got some photos of my Sherline (and Grizz) on http://plsntcov.8m.com
I would STRONGLY suggest CNCPRO instead of either version of Maxnc. I
have maxnc, have used it for quite a while. It works, but its clumsy to
use and completely strange to setup. I tried the CNCPRO demo package and
it ran the Sherline much smoother, and has a very nice interface. I just
sent in my money and got a license for cncpro.
ron
>.....
>I think thats about right. I have aboute 150 oz/in motors on my Sherline
> I am thinking of getting a Camtronics 3 axis 2amp board and getting 3
> 180 oz/in 2amp bipolar motors...I feel this should fix all of my
> concerns. What size motors are other people using on there sherline?
and they are OK. I also have the Camtronics board. I do have the
Sherline Z axis fitted with a pulley drive of about 1:1.5 ratio. I thnk
this helps on lifitng the motor. I dont mind if Z goes slower, its
little use in most work I do on the Sherline.
Ive got some photos of my Sherline (and Grizz) on http://plsntcov.8m.com
I would STRONGLY suggest CNCPRO instead of either version of Maxnc. I
have maxnc, have used it for quite a while. It works, but its clumsy to
use and completely strange to setup. I tried the CNCPRO demo package and
it ran the Sherline much smoother, and has a very nice interface. I just
sent in my money and got a license for cncpro.
ron
Discussion Thread
tauseef
2000-10-12 10:28:00 UTC
maxnc/sherline
Ron Ginger
2000-10-12 10:49:08 UTC
Re: [CAD_CAM_EDM_DRO] maxnc/sherline
Jon Anderson
2000-10-12 12:08:20 UTC
Re: [CAD_CAM_EDM_DRO] maxnc/sherline
Alan Marconett KM6VV
2000-10-12 12:31:35 UTC
Re: [CAD_CAM_EDM_DRO] maxnc/sherline
Tim Goldstein
2000-10-12 15:26:29 UTC
RE: [CAD_CAM_EDM_DRO] maxnc/sherline