Final leadscrew design - thanks to all
Posted by
r_fl_z@h...
on 2000-10-26 17:25:22 UTC
Thanks to all who helped me understand the Lead Screw stackup.
I've uploaded a Final Design file detailing, what else, but the final
design.
This one is easily built, requiring only a through hole in the
support plate. The bearing retainer plate and fasteners react the
entire thrust load, clampup is achieved without applying thrust loads
to the bearings, and only one spacer is required for a FIXED
installation (no spacer needed for a RIGID).
Much appreciation to the experts who helped.
Ron
I've uploaded a Final Design file detailing, what else, but the final
design.
This one is easily built, requiring only a through hole in the
support plate. The bearing retainer plate and fasteners react the
entire thrust load, clampup is achieved without applying thrust loads
to the bearings, and only one spacer is required for a FIXED
installation (no spacer needed for a RIGID).
Much appreciation to the experts who helped.
Ron
Discussion Thread
r_fl_z@h...
2000-10-26 17:25:22 UTC
Final leadscrew design - thanks to all
ptengin@a...
2000-10-26 18:51:54 UTC
Re: [CAD_CAM_EDM_DRO] Final leadscrew design - thanks to all
r_fl_z@h...
2000-10-26 19:14:11 UTC
Re: Final leadscrew design - thanks to all