Re: [CAD_CAM_EDM_DRO] Re: Lead screw/Guide rail install/pre-load
Posted by
ptengin@a...
on 2000-10-26 18:53:33 UTC
In a message dated 10/26/00 2:59:05 PM Hawaiian Standard Time,
hmahl@... writes:
<< I suppose the stepper would be kinda
expensive but would'nt it still be cheaper than all the bearing supports
mentioned earlier. >>
Very expensive as all those bearings etc are now in the motor....
Peter
THRD, Inc.
hmahl@... writes:
<< I suppose the stepper would be kinda
expensive but would'nt it still be cheaper than all the bearing supports
mentioned earlier. >>
Very expensive as all those bearings etc are now in the motor....
Peter
THRD, Inc.
Discussion Thread
r_fl_z@h...
2000-10-25 14:03:53 UTC
Lead screw/Guide rail install/pre-load
ptengin@a...
2000-10-25 14:51:27 UTC
Re: [CAD_CAM_EDM_DRO] Lead screw/Guide rail install/pre-load
ballendo@y...
2000-10-25 15:32:03 UTC
re:Re: Lead screw/Guide rail install/pre-load
r_fl_z@h...
2000-10-25 15:47:53 UTC
Re: Lead screw/Guide rail install/pre-load
Hugh Mahlendorf
2000-10-26 17:57:31 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lead screw/Guide rail install/pre-load
ptengin@a...
2000-10-26 18:53:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lead screw/Guide rail install/pre-load
Smoke
2000-10-26 19:10:12 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lead screw/Guide rail install/pre-load
ballendo@y...
2000-10-26 20:29:23 UTC
Re: Re: Lead screw/Guide rail install/pre-load
Ian Wright
2000-10-27 00:36:07 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lead screw/Guide rail install/pre-load
Jon Elson
2000-10-27 12:12:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: Lead screw/Guide rail install/pre-load