Re: [CAD_CAM_EDM_DRO] Re: G code software

What's CAMSOFT and where do you find it?

Smoke
-----Original Message-----
From: ptengin@... <ptengin@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Thursday, October 26, 2000 5:53 PM
Subject: Re: [CAD_CAM_EDM_DRO] Re: G code software


In a message dated 10/26/00 7:29:00 AM Hawaiian Standard Time,
drewid@... writes:

<< Thanks for the plug, Peter! What's the plan for the nice new control
system- EMC? By the way, I'm at United ARTWORKS, not ARTISTS. (I often get
calls from people asking when the movie starts... ) >>
Andrew,

No Problem. When does the movie start? Naw, I skirted the EMC thing. Went
out and bought a CAMSOFT setup and had it running in 20 minutes. Well there
was one operator error type install snag but that was quickly resolved. Now
to get the RF-45 ready for it.

Peter
THRD, Inc.

eGroups Sponsor


Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager



[Non-text portions of this message have been removed]