Re: [CAD_CAM_EDM_DRO] re: New file uploaded to CAD_CAM_EDM_DRO

No, I didn't forget. As I posted in an earlier reply...I'm assuming the opposide end of the shaft is fixed.
If the same or similar mount is used on both ends of the shaft, the shaft would be trapped between both sets of bearings and would not be able to move lengthwise.

I suppose I'll have to draw up and post a complete assembly drawing...showing all the bearings, the mounts, the ball screw nut etc.

Smoke
-----Original Message-----
From: ballendo@... <ballendo@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Friday, October 27, 2000 5:05 PM
Subject: [CAD_CAM_EDM_DRO] re: New file uploaded to CAD_CAM_EDM_DRO


re:Simple Shaft Bearing Mount.JPG (uploaded to Files area)

Smoke,

This drawing will not work! As drawn the shaft will pull the bearings
out of the housing until the leadscrew nut contacts the retaining
plate.

I think you forgot the seat for the bearings on the long leadscrew
(left) side of the mounting block. Could be either another retaining
plate, or a "step" in the bore.

Ballendo



eGroups Sponsor


Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager



[Non-text portions of this message have been removed]