Re: Linux woes

Whoops,

I should have made clear in my first reply that the files are on CD #1 of
the boxed set.

Just mount the CD while in X and then use the package manager that is in
Control Panel and click the available button and the program is set to
searching the correct directory of CD #1 by default.


Tim
[Denver, CO]

> -----Original Message-----
> From: Matt Shaver [mailto:mshaver@...]
> Sent: Thursday, July 08, 1999 8:55 PM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: Re: [CAD_CAM_EDM_DRO] Linux woes
>
>
> From: "Matt Shaver" <mshaver@...>
>
> > anyone have a clue why the patches fail? Im sure the lernel kits and the
> > updates are all clean, since I can build a kernel after installing them.
>
> 1. Are you using the patch:
>
> ftp://ftp.isd.cme.nist.gov/pub/emc/emcsoft/release9J.tgz
>
> 2. The two kernel source files you need are:
>
> ftp://updates.redhat.com/5.2/i386/kernel-source-2.0.36-3.i386.rpm
>
> and
>
> ftp://updates.redhat.com/5.2/i386/kernel-headers-2.0.36-3.i386.rpm
>
> Note: I think Tim Goldstein found these two files on CD #2 in the Red Hat
> boxed set.
>
> To make sure that you are starting with a clean slate you may
> have to remove
> everything under /usr/src/linux, then install the two kernel RPMs
> and finally
> retry the patch. See /usr/src/linux/README for more info on starting from
> scratch.
>
> Good Luck,
>
> Matt Shaver
>
> P.S. I'm sure we can get you past this little bump in the road ... and on
> your way, over the cliff!
>
>
> --------------------------- ONElist Sponsor ----------------------------
>
> ONElist members are using Shared Files in great ways!
> http://www.onelist.com
> Are you? If not, see our homepage for details.
>
> ------------------------------------------------------------------------
> Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for
> the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> bill,
> List Manager
>