Re: Vector 8 and desknc dos

> I am trying to set up a machinedriver for Desknc for dos.
> I have tryed but I get some problem with arcs. All other
> seems ok. Any suggestions how to setup machine and configure
> the start and stop macroes.
> I am going to use this for a 3d mill.

Ernst & others, I have just uploaded a DeskNC.cfg file to our web
site for download. http://www.vectorcam.com/DeskNC.cfg

It should cover most of the commands that DeskNC can process, and
arcs are set up as incremental I-J.

This one is untested, so let me know if you find any problems with it
& I will make revisions. It will export .dnc extensions files for
input to DeskNC