Re: [CAD_CAM_EDM_DRO] re:RE:Bearing Material

Hi Mr B,

I can't fault your logic but in true lunatic fashion I started the design
drawing and manufacture of this project at about the same time. Draw a bit
and then make a bit then some more drawing. Not a good way to work
but................... The bits you suggest I change are already built and
cannot be altered. I have learned for next time and there will be a next
time, it is already on the drawing board/puter.

Thanks to everyone for there suggestions.

Terry

> James,
>
> You've gotten a lot of good advice already. Here's my $.02
>
> First thought, Acetal(delrin) Easy to machine. Hard enough. Slick
> enough.(use a lube, dry or wet) See note on the alum. guide, tho!