Re: Additional Instructions for the Scripted Linux install

Tim,

Same problem. Nothing I do makes any buttons show up at the bottom of the
window.

Bob

>> Tim - I tried your scrip out last night and ran into a problem in the
>> xconfig portion. It is not obvious how to save and exit that
>> section. I
>> closed the window using the menu bar x and as the script
>> progressed it asked
>> a bunch of questions about the kernel config that I answered with the
>> default. At the end of routine lilo did not show a rtlinux.
>>
>> I started with a fresh install of workstation 5.2. ( I tried
>> also on a
>> previous attempt to install rtlinux with no luck also)
>>
>> When this works it will be a great service to people trying to get EMC
>> going! Thanks.
>>
>> Andy Olney
>
>
>I ran into the same problem on one system and forgot to mention it. The
>xconfig window has 4 buttons at the botton (Save & Exit, Exit without Save,
>Load Config from File, and Save Config to File. The real labels say
>something different, but you get the drift). Unfortunately, if you are
>running Xwindows in 640 x 480 mode you can not see these buttons and there
>is no way to scroll down to them.
>
>So, the solution is to configure Xwindows to 800 x 600 or greater
>resolution. If you do that you will see the buttons and all will work great.
>
>Please give it another try with Xwindows at 800 x 600 or more and let me
>know if it works for you.
>
>Tim
>[Denver, CO]
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>Campaign 2000 is here!
>http://www.onelist.com
>Discuss your thoughts; get informed at ONElist. See our homepage.
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager
>
>