Re: [CAD_CAM_EDM_DRO] Taper page reposted

I'd like to be able to make some tooling to fit both R8 and 5C collets.
Unfortunately, the page doesn't show the angles required for R8 and I
haven't found anything for 5C either.

Smoke
-----Original Message-----
From: ptengin@... <ptengin@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Sunday, November 12, 2000 4:25 PM
Subject: Re: [CAD_CAM_EDM_DRO] Taper page reposted

>In a message dated 11/12/00 1:15:03 PM Hawaiian Standard Time,
>Smoke@... writes:
>
><< Great Page! All it needs now is some data on 5C collets.
>
> Smoke >>
>
>Smoke,
>
> I guess you are technically right as the old hardinge mills used 5-C
>collets for tool holders. I think they have it on the collet page

otherwise.

>
>Peter
>THRD, Inc.
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>