Re: taig conversion
Posted by
Tony Jeffree
on 2000-11-18 00:48:13 UTC
At 02:06 18/11/00 +0000, you wrote:
they would not sell you one. However, I am very surprised if they were not
helpful re selling you the necessary conversion parts. They sell their
mill in a "CNC ready" form as well as fully converted to CNC.
Give Forrest Daley at Taig a call - he has always been most helpful in my
experience.
Regards,
Tony
>I picked up a taig mill for a song and I'd like to try my hand at CNC. ITaig do not have a manual for their mill, so it doesn't surprise me that
>already have a driver board and stepper motors. Has anyone on the list
>converted one without using the Taig mounts? Taig was not very helpful in
>my requests for information. They wouldn't even sell me a manual for the
>mill!
they would not sell you one. However, I am very surprised if they were not
helpful re selling you the necessary conversion parts. They sell their
mill in a "CNC ready" form as well as fully converted to CNC.
Give Forrest Daley at Taig a call - he has always been most helpful in my
experience.
Regards,
Tony
Discussion Thread
Stan Zdonick
2000-11-17 12:28:04 UTC
taig conversion
Tony Jeffree
2000-11-18 00:48:13 UTC
Re: taig conversion