Re: [CAD_CAM_EDM_DRO] Re: re:limit switches: size
Posted by
Smoke
on 2000-11-20 08:11:54 UTC
My manual vertical knee mill has a powered X axis. The power feed has a
limit switch on both ends of the travel. These switches are MUCH SMALLER
THAN A PACK OF CIGARETTES!
Check them out.
Smoke
-----Original Message-----
From: jmw@... <jmw@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Monday, November 20, 2000 3:09 AM
Subject: [CAD_CAM_EDM_DRO] Re: re:limit switches: mech vs proximity
limit switch on both ends of the travel. These switches are MUCH SMALLER
THAN A PACK OF CIGARETTES!
Check them out.
Smoke
-----Original Message-----
From: jmw@... <jmw@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Monday, November 20, 2000 3:09 AM
Subject: [CAD_CAM_EDM_DRO] Re: re:limit switches: mech vs proximity
>Thank you, ballendo, for your reply. Sorry for the bandwidth; I'lldiscussion of shop built systems, for CAD, CAM, EDM, and DRO.
>also checkout the archives.
>
>Damn; I thought limit switches were going to be one of no-brainer
>parts of this project. Maybe there are no such parts.
>
>--Jack
>
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>