Re: [CAD_CAM_EDM_DRO] Re: turn around and go back down

Wouldn't it be easier top mount the motor parallel to the X axis in
"reverse"? By that I mean instead of havig the back end of the motor stick
out from the end of the machine, extend the mounting bracket and let the
rear end of the motor be pointed toward the other end of the machine. Mount
the motor in the front or to the rear of the machine as space dictates.

Smoke
-----Original Message-----
From: jmw@... <jmw@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Monday, November 20, 2000 3:19 AM
Subject: [CAD_CAM_EDM_DRO] Re: turn around and go back down

>Well, that's good news. It would allow orienting the axis of the X
>motor in the Y direction. Wouldn't require as long a table extension
>for the long aspect ratio motor.
>
>--- In CAD_CAM_EDM_DRO@egroups.com, wanliker@a... wrote:
>> In a message dated 11/20/00 12:26:26 AM Mountain Standard Time,
>jmw@c...
>> writes:
>>
>> << but is it possbile to configure a cog
>> belt drive so the two cog wheels are not coplanar but 90 degrees
>> apart (e.g. one wheel is in the X-Y plane and the other in X-Z? >>
>>
>> Yes you can do it, run the flat side of the belt on flat pulleys
>with double
>> flanges, or toothed pulleys on the tooth side again with double
>flanges.
>> Like the old Corvair system.
>> bill
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>