L298 current spec, was OOPS! Need bigger stepper motors
Posted by
Randy Gordon-Gilmore
on 2000-11-21 23:53:23 UTC
At 04:50 AM 11/22/00 -0000, Wally wrote:
notes yesterday because the Dan Mauch 2A driver kit I recently built uses
it (and I like to have documentation on all my stuff...)
The ABSOLUTE MAXIMUM RATINGS table says:
Io Peak Output Current (each channel)
-Non Repetitive (t=100us) 3A
-Repetitive (80%on-20%off; t on=10ms) 2.5A
-DC operation 2A
Also
Vs Power Supply 50V
Vss Logic Supply Voltage 7V
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus
>I see a possible problem here, could some of you that are moreI'm not familiar with the L298 chip, but just printed out the application
>familiar with the 298 chip set confirm if the current drive of this
>chip is 2 amps not 4 amps.
notes yesterday because the Dan Mauch 2A driver kit I recently built uses
it (and I like to have documentation on all my stuff...)
The ABSOLUTE MAXIMUM RATINGS table says:
Io Peak Output Current (each channel)
-Non Repetitive (t=100us) 3A
-Repetitive (80%on-20%off; t on=10ms) 2.5A
-DC operation 2A
Also
Vs Power Supply 50V
Vss Logic Supply Voltage 7V
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus
Discussion Thread
Gary
2000-11-21 13:41:29 UTC
OOPS! Need bigger stepper motors
Alan Marconett KM6VV
2000-11-21 14:55:08 UTC
Re: [CAD_CAM_EDM_DRO] OOPS! Need bigger stepper motors
Tim Goldstein
2000-11-21 15:51:14 UTC
RE: [CAD_CAM_EDM_DRO] OOPS! Need bigger stepper motors
Wally K
2000-11-21 20:50:37 UTC
Re: OOPS! Need bigger stepper motors
Randy Gordon-Gilmore
2000-11-21 23:53:23 UTC
L298 current spec, was OOPS! Need bigger stepper motors