Re: [CAD_CAM_EDM_DRO] stepper motor question

What is easy for you, is not so simple for me. Could you send me a drawing?
Thanks
Stan


Tim Goldstein wrote:

> This would be a relatively easy task to program in a PIC microcontroller.
> You would read the voltage with the ADC and based on the result send out a
> step and direction signal to a stepper driver. I am sure there are plenty of
> other ways to do it.
>
> Tim
> [Denver, CO]
>
> > Hello list.
> > .
> > I am looking for an electronic circuit that will allow me to read a
> > voltage and then based on that voltage drive a motor in one direction to
> > raise a load or the other to lower a load. Or leave the motor alone if
> > the voltage is with in the range. I was told of a window compactor and I
> > see how it would work . A window comparitor was posted in the
> > cad-cam-dro files section and I did save it here someplace but it was
> > using a standard motor which will not work for this application because
> > a standard motor will not stop instantly and is not made to be turned
> > off and on several times a min and thus a stepper motor would be a
> > better choice. Can someone here point me in the correct direction for a
> > new or modified circuit to do the above function?
> >
> > Thanks
> > Stan
> > FAQ: http://www.ktmarketing.com/faq.html
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager