Re: Great Deal on Dual Shaft 688 oz in stepper

Sorry all the motors are spoken for as of this date.
Dan
-----Original Message-----
From: Steve Gunsel <gunsel@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Friday, July 16, 1999 12:20 PM
Subject: Re: [CAD_CAM_EDM_DRO] Great Deal on Dual Shaft 688 oz in stepper

>From: Steve Gunsel <gunsel@...>
>
>Dan,
>
>I'm definitely interested in at least three of those stepper motors, but
>how many will depend on how much of a "fraction", pricewise. If you can
>tell me the price, I will be let you know ASAP how many I would be willing
>to purchase. Thanks.
>
>Steve Gunsel
>
>
>At 08:20 PM 7/14/99 -0700, you wrote:
>>From: "Dan Mauch" <dmauch@...>
>>
>>I have come across 19 brand new Oreintal stepper motors.
>>They are double stack, DUAL shaft (.5 DiaX1.5L, nema 34 motors rated
>>at 688 oz in holding torque. They are 8 wires and can be set up as bipolar
>series, bipolar
>>parallel or used as a unipolar motor. These are very low inductance which
>>means that they will run faster . They are 5.3amps, .48 ohms resitance.
>>They run great with my 5 amp chopper driver kit These motors are in new
>>pristine conditions in the original shipping containers, They sell for
>>$400
>>retail. These motors would be ideal for a small knee mill or a mill

drill. I

>>intend to sell them at a fraction of the new price. Email me if you want

me

>>to send you a picture of the motors. These motors will be offered on
>>other sites if they don't sell here but I figured I would give you
>>guys first chance..
>>Dan
>
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>ONElist: your connection to like-minds and kindred spirits.
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager
>