CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] DesKAM 2000 vs. CNC Pro

Posted by Dan Mauch
on 2000-11-28 07:32:23 UTC
Deskam2000 is a dxf to G code translator. You must mean Desknc at the G code
interpreter.
Dan
-----Original Message-----
From: Stan Zdonick <szdonick@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Monday, November 27, 2000 1:15 PM
Subject: [CAD_CAM_EDM_DRO] DesKAM 2000 vs. CNC Pro


>I'm looking for a good, low cost, CNC control program that works with a
>step-direction controller. I have seen good things said about CNC Pro and
>DesKAM 2000. Which is the best solution for a CNC newbie? Is there
>another program I should consider?
>
>It seems to me that a Windows based program wouldn't be a good idea for CNC
>but DesKAM has gotten a good review. I use Intellicad 2000 so I can output
>dxf for conversion to g-code, if needed.
>
>I will eventually be buying a probe to interface to the system for 3D
scanning.
>
>I need something simple, but yet, I don't want to outgrow it either!
>
>Any help would be greatly appreciated.
>
>Stan
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>

Discussion Thread

Stan Zdonick 2000-11-27 13:15:59 UTC DesKAM 2000 vs. CNC Pro Joe Vicars 2000-11-27 13:21:57 UTC Re: [CAD_CAM_EDM_DRO] DesKAM 2000 vs. CNC Pro Stan Zdonick 2000-11-27 13:31:34 UTC RE: DesKAM 2000 vs. CNC Pro Dan Mauch 2000-11-28 07:32:23 UTC Re: [CAD_CAM_EDM_DRO] DesKAM 2000 vs. CNC Pro