CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re[4]: qnx

Posted by Paul Devey
on 2000-11-29 08:17:12 UTC
The RTLINUX archives while good, do not necessarily reflect reality. They
need to be updated to reflect what RTLINUX is capable of and what other OSs
are also capable of.

Paul Devey

----- Original Message -----
From: "Terry L. Ridder" <terrylr@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, November 28, 2000 4:03 PM
Subject: [CAD_CAM_EDM_DRO] Re[4]: qnx


> hello;
>
> i was thinking out load.
> considering the possibility.
> brainstorming.
>
> from now on i will keep my thoughts, brainstorming,
> ponder of possibilities to myself.
>
> On Wed, 29 Nov 2000, John Craddock wrote:
>
> john> Read the RTLinux archives.
> john> QNX doesn't come close to RTL or RTAI on latency
> john> specs and low latency is what you need for EMC
> john> especially for steppers. Why
> john> are you contemplating a port?
> john>
>
> --
> Terry L. Ridder
> Blue Danube Software (Blaue Donau Software)
> "We do not write software, we compose it."
>
> digging deep, i feel my conscience burn
> i need to know who and what i am
> this hunger jolts me from complacency
> rocks me, makes me meet myself
> ----kendall payne---closer to myself---
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>

Discussion Thread

Alan Marconett KM6VV 2000-11-28 16:13:07 UTC Re: [CAD_CAM_EDM_DRO] Re[4]: qnx Jeff Barlow 2000-11-28 16:15:22 UTC Re: [CAD_CAM_EDM_DRO] Re[4]: qnx John Craddock 2000-11-28 16:34:31 UTC RE: [CAD_CAM_EDM_DRO] Re[4]: qnx Paul Devey 2000-11-29 08:17:12 UTC Re: [CAD_CAM_EDM_DRO] Re[4]: qnx