CAD CAM EDM DRO - Yahoo Group Archive

interpolation and algorithms of multiple axes was Re: Pulse Gen

Posted by Wally K
on 2000-12-06 11:13:11 UTC
--- In CAD_CAM_EDM_DRO@egroups.com, ballendo@y... wrote:
> Alan, Wally,
>
> Not sure what you're looking for here. I think Alan wants to know
how
> to do interpolated moves of multiple axes? Wally wants
a "driver???"
> for EMC?



I want a open source, simple, low cost, hardware add on for EMC.
That will let me run steppers up to 13.3k half steps per second for a
200IPM rapid with a 2-1 belt reduction. It would be nice if this
device would also run 10 micro step drives up to 200IPM, ?66.5K steps
pes second, if this does not add much complexity and cost. This
hardware device should be able to be used with other programs as well
like master control, with the proper driver.

I went back and read Alans posts again. Maybe it is wishfull
thinking but that seems to be the sort of thing he is talking about.
If i am wrong maybe he will take a hint.


Wally K.

Discussion Thread

ballendo@y... 2000-12-06 03:12:25 UTC interpolation and algorithms of multiple axes was Re: Pulse Gen Wally K 2000-12-06 11:13:11 UTC interpolation and algorithms of multiple axes was Re: Pulse Gen ballendo@y... 2000-12-09 15:12:05 UTC Re: interpolation and algorithms of multiple axes was Re: Pulse Gen Ian Wright 2000-12-10 06:08:44 UTC Re: [CAD_CAM_EDM_DRO] Re: interpolation and algorithms of multiple axes was Re: Pulse Gen Mariss Freimanis 2000-12-10 08:06:20 UTC interpolation and algorithms of multiple axes was Re: Pulse Gen Carlos Guillermo 2000-12-10 13:40:48 UTC RE: [CAD_CAM_EDM_DRO] Re: interpolation and algorithms of multiple axes was Re: Pulse Gen Carlos Guillermo 2000-12-10 13:40:50 UTC RE: [CAD_CAM_EDM_DRO] interpolation and algorithms of multiple axes was Re: Pulse Gen Alan Marconett KM6VV 2000-12-10 17:58:22 UTC Re: interpolation and algorithms of multiple axes was Re: Pulse Gen