Re: [CAD_CAM_EDM_DRO] black box specs

The easy way then is to connect them using a cross over cable. You shouold
be able to get this at a local computer shop.

Smoke
-----Original Message-----
From: Jeff Barlow <jeff@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Thursday, December 07, 2000 9:20 PM
Subject: Re: [CAD_CAM_EDM_DRO] black box specs

>Smoke,
>
>5. is what I had in mind. I don't really want a network at all.
>
>Jeff
>
>On Thu, 7 Dec 2000 21:02:27 -0700, you wrote:
>
>>Jeff, you can isolate the computers on your network in at least five
>>(simple) ways that I can think of:
>>1. Using subnets masks
>>2. Protocol bindings
>>3. Workgroup names
>>4. Use different network protcols
>>5. Direct (separate) cabling
>>
>>Smoke
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>