Re: [CAD_CAM_EDM_DRO] Software 2d 2.5d 3d PCB

I'd be interested. I've got a number of parts to machine that this program
would work well with.

I don't have Corel or AutoCad but I do have QuickCAD, which is an offshoot
of AutoCad. However, I could try it using AutoCad and the big CNC mill over
at the college. They probably have Corel over there too in the computer
department.

You can contact me at Smoke@...

Smoke

>Hello folks,
>Over the past Months I have developed a easy to use CNC programm.
>This program takes a line drawing and mills each line, cutting
>different lines to different depths. I use it extensivly with Corel
>Draw to make little door plates and prototypes for jewlery.
>
>It operates as follows:
>imports HPGL (.PLT) file
>re-organises it to minimise tool chnages
>perviews mill paths on screen.
>Cuts desierd path stopping if desired for tool changes.
>
>It is a fairly simple DOS application.
>It can be configured(in software) for any paralell port pin
>combination.
>
>I would be very interested in giving it to anyone who works in 2d (or
>would like to cut different hights according to different colours)
>I have not tested it with Autocad hpgl. Perhaps someone could send me
>one or two small hpgl files generated by autocad. It is limited as
>yet to 32000 steps.
>
>Regards,
>Bernard Bryce.
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>
>