Re: Majority of CNC conversions?
Posted by
Randy Gordon-Gilmore
on 2000-12-08 14:36:22 UTC
At 12:11 PM 12/8/00 -0800, Mike Mueller wrote:
driver board, and a 24V, 8.5A switching power supply.
Although the motors aren't on the mill yet, I did accomplish "hello world"
last night when I jogged a motor both ways using DeskNCrt. The motor is
turning pretty roughly, so I have some troubleshooting/learning curve to
work on this weekend with all the parameters...
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus
>Sorry if this has been covered before but I was wondering what the majorityI'm converting a Sherline mill with their motors and mounts, Dan Mauch 2A
>of you guy's have or are converting to CNC?
driver board, and a 24V, 8.5A switching power supply.
Although the motors aren't on the mill yet, I did accomplish "hello world"
last night when I jogged a motor both ways using DeskNCrt. The motor is
turning pretty roughly, so I have some troubleshooting/learning curve to
work on this weekend with all the parameters...
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.rickadee.net/~zephyrus
Discussion Thread
Randy Gordon-Gilmore
2000-12-08 14:36:22 UTC
Re: Majority of CNC conversions?
Smoke
2000-12-08 15:55:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: Majority of CNC conversions?
Al Lenz
2000-12-08 21:24:01 UTC
Re: Majority of CNC conversions?
tauseef
2000-12-08 21:44:54 UTC
Re: Majority of CNC conversions?
Wally K
2000-12-08 23:12:55 UTC
Re: Majority of CNC conversions?
Smoke
2000-12-08 23:29:59 UTC
Re: [CAD_CAM_EDM_DRO] Re: Majority of CNC conversions?
Dan Mauch
2000-12-09 07:24:29 UTC
Re: [CAD_CAM_EDM_DRO] Re: Majority of CNC conversions?
Peter Smith
2000-12-12 18:55:50 UTC
Re: [CAD_CAM_EDM_DRO] Re: Majority of CNC conversions?