Re: Homebrew RP?
Posted by
Randolph Lee
on 1999-07-20 12:18:52 UTC
>From: Andrew Werby <drewid@...>Humm Well I have PR material from them dated 1995 that quotes a price
>
>Message: 2
> Date: Sun, 18 Jul 1999 10:06:12 -0400
> From: Randolph Lee <boss@...>
>Subject: Desktop Rapid Prototype
>
>As far as I know there Are only a few companies doing Desktop Rapid Prototype
>
>I saw one of them in action a few years ago At EasTec...
>http://www.sanders-prototype.com/main.html
>It does work like (and is about the same size as) an inkjet
>printer... putting down 2 types of plastic (for the part itself and
>for the undercut support... that latter can be dissolved away) after
>each pass the main trick is they run a planer blade over the surface
>Between each pass to create an exact thickness for each layer... they
>were selling rebuilt Modelmaker I units for about $2000 last
>winter... might be worth contacting them to see if they had any
>left...
>
>[They laughed when I asked about that- these things go for $40k used, and
>$56K new. Too bad- I was seriously tempted. They do seem to get some pretty
>good surface detail, if the photos on their site are to be believed. I'm
>sending off for an actual sample. ]
of $20,000 for the the first version of their 3D printer and I think
that price included an IBM PC... and while I may have disremembered
the Price I saw last year on the used versions of their first unit
and just chopped a zero off the original price in my mind... on
further reflection though I am sure that the web page I saw last year
was not asking for more than $5 or 6 thousand... what I am not sure
of is if they were selling them or it was a 2ed party web site I
found with a search engine... memory is tricky thing and as I get
older I seem to be less and less able to rely on it... sorry if I got
your hopes up on this.....
the 40k to 56k sounds right for their current and much larger Version
that they have sold for the last few years
Snip
Randolph Lee boss@...
---------------------------------------------------------
Windshadow Engineering Nantucket Island, MA USA
---------------------------------------------------------
Discussion Thread
Andrew Werby
1999-07-20 03:36:53 UTC
Re: Homebrew RP?
Randolph Lee
1999-07-20 12:18:52 UTC
Re: Homebrew RP?
Al Schoepp
1999-07-20 13:36:21 UTC
Re: Re: Homebrew RP?
Randolph Lee
1999-07-20 14:15:03 UTC
Re: Re: Homebrew RP?