CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] GS-D200S

Posted by Dan Mauch
on 2000-12-12 07:53:39 UTC
I have been using those modules for about 3 years. You need a printed
circuit board to mount them. I sell a couple products that aren't listed on
my web site that are designed around them. The only problem with them is
that they don't have auto current reduction. So I have designed a little
board that adds that feature to them. A variety of stepper motor dealers
sells them. Pacsci and General as well as Superior Electric all use them.
Dan
-----Original Message-----
From: Greg Nuspel <nuspel@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Tuesday, December 12, 2000 6:44 AM
Subject: [CAD_CAM_EDM_DRO] GS-D200S


>I was wondering if anyone had experience with the GS-D200S bipolar stepper
>motor drive module http://www.st.com/stonline/books/ascii/docs/2666.htm . I
>was wondering if this unit is worth while using. Since it has everything in
>one package and looks to be well protected from shorts etc.
>
>
>-- Greg Nuspel
>

Discussion Thread

Greg Nuspel 2000-12-12 06:45:49 UTC GS-D200S Dan Mauch 2000-12-12 07:53:39 UTC Re: [CAD_CAM_EDM_DRO] GS-D200S Alan Marconett KM6VV 2000-12-12 11:44:04 UTC Re: [CAD_CAM_EDM_DRO] GS-D200S Alan Marconett KM6VV 2000-12-12 11:56:29 UTC Re: [CAD_CAM_EDM_DRO] GS-D200S Greg Nuspel 2000-12-12 12:31:34 UTC Re: [CAD_CAM_EDM_DRO] GS-D200S Dan Mauch 2000-12-12 13:28:26 UTC Re: [CAD_CAM_EDM_DRO] GS-D200S