Re: [CAD_CAM_EDM_DRO] GS-D200S

Dan,

I just posted a reply to Greg on my appraisal of the Superior Electric
modules I have. What did you do for auto current reduction? A 555
timer type of delay to disable the "enable" line? I guess I'm committed
to using at least 4 of these modules, so I'd be interested in learning
anything I can about them.

Do you have a PCB for three modules? or a kit (sans modules)? I'd be
interested. I've had these modules WAY too long without getting them up
and running.

Alan KM6VV


Dan Mauch wrote:

>
> I have been using those modules for about 3 years. You need a printed
> circuit board to mount them. I sell a couple products that aren't listed on
> my web site that are designed around them. The only problem with them is
> that they don't have auto current reduction. So I have designed a little
> board that adds that feature to them. A variety of stepper motor dealers
> sells them. Pacsci and General as well as Superior Electric all use them.
> Dan
> -----Original Message-----
> From: Greg Nuspel <nuspel@...>
> To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
> Date: Tuesday, December 12, 2000 6:44 AM
> Subject: [CAD_CAM_EDM_DRO] GS-D200S
>
> >I was wondering if anyone had experience with the GS-D200S bipolar stepper
> >motor drive module http://www.st.com/stonline/books/ascii/docs/2666.htm . I
> >was wondering if this unit is worth while using. Since it has everything in
> >one package and looks to be well protected from shorts etc.
> >
> >
> >-- Greg Nuspel
> >
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager