Re: Servo drive
Posted by
Dan Mauch
on 1999-07-21 06:33:30 UTC
-----Original Message-----
From: Arne Chr. Jorgensen <instel@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Tuesday, July 20, 1999 11:59 AM
Subject: [CAD_CAM_EDM_DRO] Servo drive
From: Arne Chr. Jorgensen <instel@...>
To: CAD_CAM_EDM_DRO@onelist.com <CAD_CAM_EDM_DRO@onelist.com>
Date: Tuesday, July 20, 1999 11:59 AM
Subject: [CAD_CAM_EDM_DRO] Servo drive
>From: "Arne Chr. Jorgensen" <instel@...>I sell stepper motor systems and servo systems.
>
>Hi again,
>
>Bill & Dan:
>---------
>
>I am a little confused ! I went to www.metalworking.com and looked
>at the pictures of the CNC conversion project, - and I didn't
>understand that it was a DC-motor servo system ! ( real dope..)
>All the time I had thought you were doing stepper drives.
>You'll have to talk to bill about that.
>So now I am very curious, - I am working on something too, - but I
>mine doesn't work any good. Is there any change to get plans ?
>Yes
>Second, can you tell a little how this works ?
>You have an external case, with amps and a controller ?
>How is this interfaced - serial or parallel ?Parallell
>Do you run EMC ?Not yet
>The servo amps: do you have a DC-feedback tacho ?yes they have a optical encoder.
>discussion of shop built systems in the above catagories.
>I working on a system (30V/2A ), but I don't get the response I
>should, so I am trying to add tacho feedback, but I have some
>problems with it. I need to do some redesign, - and I am looking
>for other ways to do it.
>
>//ARNE
>
>
>
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>ONElist: your connection to like-minds and kindred spirits.
>
>------------------------------------------------------------------------
>Welcome to CAD_CAM_EDM_DRO@...,an unmodulated list for the
>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>bill,
>List Manager
>
Discussion Thread
Arne Chr. Jorgensen
1999-07-20 11:57:34 UTC
Servo drive
Dan Mauch
1999-07-21 06:33:30 UTC
Re: Servo drive