CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Re: spindle was Re: Re: spindle motors

Posted by Marcus & Eva
on 2000-12-15 07:55:05 UTC
Hi Ballendo:
Nope, this is the stock Defiance spindle (on the old model... the new
one runs at 40,000 rpm).
I will post everything I find out about this spindle as soon as the Defiance
engineer gets back to me.

Cheers

Marcus
-----Original Message-----
From: ballendo@... <ballendo@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Thursday, December 14, 2000 3:10 PM
Subject: [CAD_CAM_EDM_DRO] Re: Re: spindle was Re: Re: spindle motors


>Marcus,
>
>Did you make this spindle? If not, who did? HP of motor?
>More details, please?
>
>I'm sure others are interested in a SIMPLE, PROVEN spindle design!
>
>Ballendo
>
>'********************************************************************
>Hi Jon:
> I run 9 hour shifts, 6 days a week. My spindle run time is about
>60%.
>I cut 90% plastics, 5% aluminum and 5% steel on this machine.
>I cut dry 100% of the time in plastics, and I do squirt can lube with
>aluminum and steel.
>But: my spindle can't weigh more than 3 or 4 pounds, and I think that
>is
>what makes the biggest difference.
>They are also small diameter and close to the spindle nose.
>The whole setup is more like a powerplane or a router, than a milling
>spindle.
>
>Cheers
>
>
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager

Discussion Thread

ballendo@y... 2000-12-14 15:08:05 UTC Re: Re: spindle was Re: Re: spindle motors Smoke 2000-12-14 17:41:20 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: spindle was Re: Re: spindle motors Marcus & Eva 2000-12-15 07:55:05 UTC Re: [CAD_CAM_EDM_DRO] Re: Re: spindle was Re: Re: spindle motors