Gecko G201 heat sink question
Posted by
Terry Toddy
on 2000-12-23 13:02:04 UTC
If two Gecko drives are bolted to the steel 14 guage inner pan in my
NEMA 12 electrical enclosure will that provide an adequate heat sink to
run the drives near capacity? The pan is about 20" x 20" with a 1KVA
transformer and a bridge rectifier and couple of control relays, not
much heat.
Thanks for your input,
Terry
NEMA 12 electrical enclosure will that provide an adequate heat sink to
run the drives near capacity? The pan is about 20" x 20" with a 1KVA
transformer and a bridge rectifier and couple of control relays, not
much heat.
Thanks for your input,
Terry
Discussion Thread
Terry Toddy
2000-12-23 13:02:04 UTC
Gecko G201 heat sink question
Mariss Freimanis
2000-12-24 10:08:12 UTC
Re: Gecko G201 heat sink question
Tim Goldstein
2000-12-24 10:21:40 UTC
DanCAD 3D website
Terry May
2000-12-24 11:07:24 UTC
Re: DanCAD 3D website
Dan Falck
2000-12-24 13:41:21 UTC
Re: DanCAD 3D website
Terry Toddy
2000-12-27 09:37:37 UTC
Re: Gecko G201 heat sink question