Re: Gecko G201 heat sink question
Posted by
Mariss Freimanis
on 2000-12-24 10:08:12 UTC
Hi,
Steel is a miserable heat conductor. Even if you used aluminum, a
plate is a very poor heatsink. The heat would have to travel
laterally thru what is a very thin cross section. Be thinking instead
of a heatsink section 4" by 6" with fins at least 1" deep. If a fan
is used, the sink can be smaller. Also use thermal grease, (the white
gunk) between the drive and heatsink.
Mariss
Steel is a miserable heat conductor. Even if you used aluminum, a
plate is a very poor heatsink. The heat would have to travel
laterally thru what is a very thin cross section. Be thinking instead
of a heatsink section 4" by 6" with fins at least 1" deep. If a fan
is used, the sink can be smaller. Also use thermal grease, (the white
gunk) between the drive and heatsink.
Mariss
--- In CAD_CAM_EDM_DRO@egroups.com, Terry Toddy <tltoddy@c...> wrote:
> If two Gecko drives are bolted to the steel 14 guage inner pan in my
> NEMA 12 electrical enclosure will that provide an adequate heat
sink to
> run the drives near capacity? The pan is about 20" x 20" with a 1KVA
> transformer and a bridge rectifier and couple of control relays, not
> much heat.
>
> Thanks for your input,
>
> Terry
Discussion Thread
Terry Toddy
2000-12-23 13:02:04 UTC
Gecko G201 heat sink question
Mariss Freimanis
2000-12-24 10:08:12 UTC
Re: Gecko G201 heat sink question
Tim Goldstein
2000-12-24 10:21:40 UTC
DanCAD 3D website
Terry May
2000-12-24 11:07:24 UTC
Re: DanCAD 3D website
Dan Falck
2000-12-24 13:41:21 UTC
Re: DanCAD 3D website
Terry Toddy
2000-12-27 09:37:37 UTC
Re: Gecko G201 heat sink question