Re: Step & Direction 3 axis board plan

Uh, Easy for you to say that, not so easy for me to do ;-)
Do you have a PCB artwork at hand for this?

Matjaz

Message: 24
Date: Thu, 4 Jan 2001 02:25:26 -0000
From: "James Owens" <>

Take a look at the data sheet for the NJM3517D2 driver chip. If you don't
want much power out it could be your solution. If you require more than
500ma you will have to hang some Fet's off the back in a H-Bridge, try
IRLZ24's. These are logic level Fet's and should not require drivers to fire
them. You should also look at the L297-L298 combination to achieve the same
ends.

Terry