Re: [CAD_CAM_EDM_DRO] Step & Direction 3 axis board plan

Matjaz,
If it is a stepper-driver that you are looking for I have built one using
the L297/298 combo.
If you want the files (schematic & PCB-layout) say the word they are yours
(~500kB zip).
If you would like more info just ask.

/Henrik Olsson.

----- Original Message -----
From: "Kos" <kos@...>

> Dear lister!
>
> You guys and ladies (any?) are doing a great job and since on the list I
> have learned a lot from you!
> I am in an early stage of building a tiny milling machine to use it for
fun
> (next to my printer on my desktop ;-). I have found quite some amount of
> freeware and shareware on the web and have found out that there are
several
> approaches to motion control of three stepper motors. I se that the most
> common one is step&direction approach using only two pins to control one
> motor. I would like to build a motion control card like that, but I can
not
> find any plans on the web for it. Any of you listers have them and willing
> to share them with others? I would be immensely happy to se one published.
>
> With best regards, Matjaz
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>