Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Posted by
Drew Rogge
on 2001-01-05 11:43:08 UTC
On Jan 5, 1:48pm, Les Watts wrote:
Back in the good old days (early 70's) when I was a machinist at Lawerence
Livermore Labs we had some Ex-Cello T lathes which used this same technique.
Calibration was done with laser interferometers and the cams were filed/stoned
on the machine.
Drew Rogge
drew@...
> Subject: [CAD_CAM_EDM_DRO] Making leadscrews more accurateVery nice description snipped.
> > Les wrote:
> > >Rather than XXYZ control the minor pitch variation between the two x
> > >screws is taken out by a simple cam/rotating ballnut.
> > >It's an old victorian trick to make a leadscrew's pitch more
> > >accurate than it was manufactured to.
> >
> > Les,
> >
> > Please tell us more about this! And/Or post links/Refs??
> >
>
>
> Well I have no links because I know of no other one that has done this. I do
> seem to recall reading about the early machine makers in the 1800's using
> this technique to make leadscrews though. (Maudsley?)
Back in the good old days (early 70's) when I was a machinist at Lawerence
Livermore Labs we had some Ex-Cello T lathes which used this same technique.
Calibration was done with laser interferometers and the cams were filed/stoned
on the machine.
>--
> Les
>
> Leslie Watts
> L M Watts Furniture
> Tiger, Georgia USA
> http://www.rabun.net/~leswatts/wattsfurniturewp.html
>
>-- End of excerpt from Les Watts
Drew Rogge
drew@...
Discussion Thread
Les Watts
2001-01-05 11:00:26 UTC
[CAD_CAM_EDM_DRO] Making leadscrews more accurate
Drew Rogge
2001-01-05 11:43:08 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Smoke
2001-01-05 11:52:06 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Carlos Guillermo
2001-01-05 12:17:54 UTC
RE: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Les Watts
2001-01-05 13:29:53 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Smoke
2001-01-05 15:22:34 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Ian Wright
2001-01-05 15:37:14 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Les Watts
2001-01-05 16:10:43 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Jon Elson
2001-01-05 16:19:20 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
Smoke
2001-01-05 21:24:16 UTC
Re: [CAD_CAM_EDM_DRO] Making leadscrews more accurate
ballendo@y...
2001-01-06 15:45:47 UTC
re:Making leadscrews more accurate
ballendo@y...
2001-01-06 15:50:13 UTC
Re: Making leadscrews more accurate